The add on PTS block is designed to simplify the addition of fuel pressure and temperature sensors. Adding just 27mm to the overall width of the assembly, in many cases it can be installed without the need to make new hoses. It installs with two screws, and re-uses your original hose end fitting. With the exception of wiring, it can be installed in a matter of minutes. It features a high quality Bosch Motorsport 0-10 bar gauge fuel pressure sensor, and a -40C to 140C fuel temperature sensor.
Specifications/Limitations
O-rings: Fluorosilicone
Body: Aluminum 6061-T651, Type II Anodized
Fasteners: 18-8 Stainless Steel
Filter Media: Microglass
Media Compatibility: All known automotive fuels.
Maximum Operating Temperature: 110 °C
Maximum Operating Pressure: 10 bar
Maximum Differential Pressure: 1 bar
Maximum Flowrate: See DeltaP vs Flow and Contaminant Level Chart, page 4
Burst Pressure: 35 bar
Inlet/Outlet Configuration: -8 SAE J1926 Port (9/16-18 ORB)
PTS Block Fasteners: Socket head screw, M6x1.0x25
Bracket Fasteners – Bracket to Body : Cup point set screw, M6x1.0x10
Bracket Fasteners – Bracket to Vehicle: Supplied M4x0.7x25
Note: The ID F750 is not intended for use on the high pressure side of a DI fuel system. It will fail immediately, and catastrophically.
Universal Product For All Evo Models. Only to fit on with the Injector Dynamics F750 Fuel Filter.
Stock Images Used. Actual Product May Vary.